Доработка штатной выпускной системы 540

[Arstan]

цитирую

Еxhaust Options with the M-tech Bumper

One of the problem I ran into with the rear bumper install was getting the right exhaust fitment. I had a Supersprint exhaust priot to the install. As it turns out, I could not find any aftermarket exhaust that would fit the new exhaust location (closer to center and higher) without some sort of custom exhaust work. The only options I came up with were: 1. Go with a M5 OEM driver side exhaust (new bracket required and trim insert piece), 2. buy an aftermarket M5 driver side only exhaust (new bracket required and trim insert), 3. get a custom built exhaust, 4. modify my Supersprint to make it fit right (cutting the tips off and reweld it straight, also require new bracket and insert trimming), and lastly, 5. and perfit fitment way...reinstall my OEM 540 exhaust and go with a single or dual outlet.

After due consideration, I opted to reinstall my OEM exhaust, and had the shop custom build me a new 3" outlet pipe with a single 4" tip. I was extremely pleased with the end result. However, I wanted to make it sound like my old Supersprint, so I removed the center resonator for testing. Wow, I could not believe the sound!!! It actually sounds like the Supersprint, but the tone is a bit higher. If you didn't look at my exhaust, you would think I have some kind of aftermarket or custom exhaust by the way it sounded, and the way it looked.