[Cashback]

Да еще, после чистки все становится вот в таком виде и держится пока не выпадет в аварийный режим.
# ERRORS IN UNITS
---------------------------------------------------------------------------------------------------------------------------
Unit BMWTNR HW SW-FSW ERRORS / SHADOW-MEMORY
---------------------------------------------------------------------------------------------------------------------------
DME -> 7.500.255 15 E3 no errors / 6 errors
EGS -> 1.423.642 28 19 no errors
EWS -> 6.905.668 03 08 no errors
ABS -> 6.756.342 53 03 1 error
A/C -> 6.901.628 03 14 no errors
SRS -> 6.900.727 38 25 no errors
IKE -> 6.906.124 12 13 1 error
LCM -> 8.386.208 01 41 no errors / 1 error
ZKE -> 6.901.226 20 22 4 errors / no errors
MFL -> 0.000.000 01 08 no data
PDC -> 6.904.023 01 13 no errors
AIC -> 6.904.012 04 14 no errors
RAD -> 6.907.130 10 00 no errors
TEL -> 0.907.046 10 12 no data
SZM -> 8.373.712 27 F8 no errors / no errors
VID -> 6.906.923 04 10 no errors / no errors
NAV -> 6.942.908 10 00 no errors / 2 errors
VMGP -> 6.942.908 10 00 no data
BMBT -> 6.915.516 43 42 2 errors
SES -> 6.905.967 08 13 no errors
LRA -> 8.375.964 C6 05 no errors / no errors


# ERRORS DETAILS - DTC(hex)/PARAM(hex)
---------------------------------------------------------------------------------------------------------------------------
DME -> Shadow-memory:
32/14 - Activation, solenoid valve, fuel-circuit changeover
85/08 - Signal, CAN ASC 3
23/12 - Activation, relay, secondary-air pump
3E/12 - Activation, solenoid valve, secondary air
7E/12 - Activation, solenoid valve, tank-leak diagnosis pump
7F/02 - Activation, solenoid valve, suction-jet pump

ABS -> 4C/F5 - CAN DDE message error

IKE -> BF/48 - Internal fault, EEPROM checksum, coding incorrect/incomplete

LCM -> Shadow-memory:
5B/01 - Level washer fluid

ZKE -> AB/02 - Short circuit mirror motor horizontal, driver's door
A1/21 - Short circuit mirror heating or cable, driver's door
DD/01 - Steering column angle: short circuit
96/21 - Interior security rear: fuse or cable

BMBT -> 16/21 - EEPROM Checksum does not match with programmed value
0B/1E - I-Bus sending error


# SCAN END