Re: Загорелось EML
переведешь сам я надеюсь (хотя тут говорят что проблема в дросселе....но ты его вроде как менял)
MOTOR DRIVEN THROTTLE VALVE(MDK)
MODELS AFFECTED:
E 39-528i/iA with M52TU engine produced 9/98
E 46-323i/iA &328i/iA with M52TU engine produced 6/98
Z3-Roadster with 2.5L/2.8L engine and Mcoupe with 2.8L Engine produced 9/98
FAULT:
The check engine light is on and one or more of the following faults are Set in the ECM/DME:
FAULT CODES:
109(6D)-Plausibility of motor driven throttle valve
110(6E)-Signal, drivers wish sensor potentiometer 1.
111(6F)-Signal, drivers wish sensor potentiometer 2.
112(70)-Signal, throttle position sensor potentiometer 1.
113(71)-Signal, throttle position sensor potentiometer 2.
114(72)-Motor throttle valve final stage.
115(73)-Reference voltage, voltage regulator 1
116(74)-Reference voltage, voltage regulator 2
117(75)-Plausibility signal, drivers wish sensor potentiometer 1&2
118(76)-Plausibility signal, motor driven throttle valve sensor, potentiometers 1&2
119(77)-MDK throttle mechanical sticking.
120(78)-Pedal sensor, throttle valve potentiometer.
172(AC)-Signal, drivers wish sensor, potentiometers 1&2 short circuit.
173(AD)-Signal, throttle position sensor, potentiometers 1&2 short circuit.
175(AF)-Drivers wish sensor 1,adaptation.
176(BO)-Drivers wish sensor 2, adaptation.
169(A9)-Motor-drive throttle valve output stage cutoff after diagnosis fault.
170(AA)-Control unit self test, internal fault.
171(AB)-Plausibility motor driven throttle valve.
CAUSE:
The faults above cold be set due to the following:
· Break/open in the wiring from the DME to the throttle motor(MDK).
· The actuator or potentiometers inside the MDK could be contaminated.
SOLUTION:
(If any of the faults listed are set)
· Using a breakout box check for an open or short to ground in the wiring from the DME to the MDK.
· If the wiring is intact then replace the MDK, then the adaptation values in the DME must be
cleared. Failure to do this will result in reoccurring faults.
· Switch the ignition off for 30 seconds.
· Turn on the ignition and delete the DME adaptations and the fault code
memory
· Press the accelerator pedal to wide open throttle(WOT)4 times
__________________
Olivin retrofit: FLA, Anti roll bar М6, Final drive I=4.1, Mulf2 High usb\aux, M-pack, Shadow, "SPORT" button, rear cigarette lighter, 348/30 front brakes, HUD
Последний раз редактировалось Александр М60; 30.08.2011 в 02:36.
|